YOKOGAWA FA-M3 Vitesse, User Manual

Page: 56 / 76

9-2
IM 34M6H33-01E 1st Edition : July 1.2004-00
9.2 Monitoring Function
After connecting the RS-232C cable, power on the module. The following message will
be displayed.
-------------------------------------
Enable terminal interface menu
-------------------------------------
Yes - Enter
-------------------------------------
If you have connected the RS-232C cable with the module already switched on, then
press the <ESC> key.
Press <Enter>. The main menu is displayed.
-------------------------------------
AnyBus M ASI Main Menu
-------------------------------------
1 - View scan-lists
2 - View all nodes
3 - View all detected nodes
4 - View single node
5 - Toggle Protected/Configuration
6 - Toggle online/offline
7 - Toggle auto addr. ON/OFF
8 - Save configuration
-------------------------------------
ASi master status:
Offline phase active: False
Power fail: False
Normal operation: True
Slave 0 exist: False
Config mismatch: True
Mode: Configuration
Autoprogramming: Not possible
Bus status: Online
EEPROM status: Ok
Auto addressing: Enabled
>
CAUTION
When the monitor enters connected mode, input relay X □□□ 32 turns on, and
input/output update from user programs is suspended.
Once the monitor port connection is disconnected, normal operation resumes. For
information on how to cancel a connection, read the help information provided with the
terminal emulator software.