YOKOGAWA Dpharp vigilantplant EJA110A, User Manual

Page: 16 / 40

<2. Handling Cautions>
14
IM 01C22A01-01E
(2) Technical Data
• Models without /PE3
Article 3, Paragraph 3 of PED, denoted as Sound
Engineering Practice (SEP) .
• Models with /PE3
Module: H
Type of Equipment: Pressure Accessory - Vessel
Type of Fluid: Liquid and Gas
Group of Fluid: 1 and 2
Model
PS*
1
(bar)
V(L)
PS-V
(bar-L)
Category*
2
EJA110A 160 0.01 1.6
Article 3,
paragraph 3 (SEP)
EJA120A 0.5 0.01 0.005
Article 3,
paragraph 3 (SEP)
EJA130A 420 0.01 4.2
Article 3,
paragraph 3 (SEP)
EJA130A
With code /PE3
420 0.01 4.2 III
EJA310A 160 0.01 1.6
Article 3,
paragraph 3 (SEP)
EJA430A 160 0.01 1.6
Article 3,
paragraph 3 (SEP)
EJA440A 500 0.01 50
Article 3,
paragraph 3 (SEP)
EJA440A
With code /PE3
500 0.01 50 III
EJA510A 500 0.01 50
Article 3,
paragraph 3 (SEP)
EJA510A
With code /PE3
500 0.01 50 III
EJA530A 500 0.01 50
Article 3,
paragraph 3 (SEP)
EJA530A
With code /PE3
500 0.01 50 III
*1: PS is maximum allowable pressure for vessel itself.
*2: Referred to Table 1 covered by ANNEX II of EC Directive
on Pressure Equipment Directive 97/23/EC.
(3) Operation
CAUTION
• The temperature and pressure of
fl
uid should be
applied under the normal operating condition.
• The ambient temperature should be applied under
the normal operating condition.
• Please pay attention to prevent the excessive
pressure like water hammer, etc. When water
hammer is to be occurred, please take measures
to prevent the pressure from exceeding PS by
setting the safety valve, etc. at the system and the
like.
• When external
fi
re is to be occurred, please take
safety measures at the device or system not to
in
fl
uence the transmitters.
2.7 Low Voltage Directive
Applicable standard : EN61010-1
(1) Pollution Degree 2
"Pollution degree" describes the degree to which
a solid, liquid, or gas which deteriorates dielectric
strength or surface resistivity is adhering. " 2 " applies
to normal indoor atmosphere. Normally, only non-
conductive pollution occurs. Occasionally, however,
temporary conductivity caused by condensation must
be expected.
(2) Installation Category I
"Overvoltage category(Installation category)"
describes a number which de
fi
nes a transient
overvoltage condition. It implies the regulation for
impulse withstand voltage. " I " applies to electrical
equipment which is supplied from the circuit when
appropriate transient overvoltage control means
(interfaces) are provided.