12
IM 701924-01E
Product Specifications
Electrical Specifications
(The electrical specifications are based on standard operating environment after
30-minute warm-up.)
Frequency bandwidth
DC to 1 GHz (–3 dB or higher)
Attenuation ratio
50:1
DC voltage accuracy
1
±2 % of differential input voltage (at 50 Ω load)
2
Input capacitance
Approx. 1.1 pF (relative to ground, typical value
3
)
Input resistance
1 MΩ ± 3% (relative to ground)
Output impedance
Approx. 50 Ω (typical value
3
)
Maximum operating input voltage
4,5
±35 V (DC + ACpeak)
Maximum differential input voltage
4
±25 V (DC + ACpeak)
Maximum non-destructive input
voltage
6
±100 V (instantaneous)
Maximum non-destructive
continuous input voltage
5
±35 V (DC + ACpeak)
Rise time
350 ps or less (excluding characteristics of the
oscilloscope, typical value
3
)
Residual noise
500 μVrms or less
(at probe output, typical value
3
)
Residual offset
7
±10 mV
Common mode rejection ratio
DC to 1 MHz:
–35 dB or less
1 MHz to 10 MHz
–30 dB or less
10 MHz to 100 MHz: –26 dB or less
100 MHz to 300 MHz: –20 dB or less
1 Excluding the residual offset voltage. See Appendix 2 for details.
2 Under the standard operating environment. Excluding the oscilloscope errors.
3 Typical values represent typical or average values. They are not strictly guaranteed.
4 For the relationship between the differential input voltages and the operating input
voltages, see the figure “Input voltage range” on the next page.
5 Depending on the frequency. See the figure “Derating of the input voltage by
frequency” below.
6 Maximum instantaneous voltage that will not break the probe. It is not the rated
voltage that you can use continuously. For continuous usage, use it within the
maximum operating input voltage.
7 When 0 V is applied to both positive and negative input terminals. After offset
adjustment.
1
10
100
1
10
100
1000
Frequency (MHz)
Derating of the input voltage by frequency
Maximum non-destructive
continuous input voltage range
(V peak)
