ENGLISH
２９
dimming, and then press
. Water will flow out. Wait until water stops flowing out.
FROTHING MILK/PRODUCING STEAM TO HOT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate, water or tea.
Method 1: Frothing milk
1. Remove the removable tank and fill it with desired water, the water level should not exceed t
he “MAX”
mark in the tank. Then insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press
to turn on the unit, and wait until the heating indicator turns blue.
4. Make sure that the steam knob is at the
“O” position.
5. Press
and wait until the steam indicator stops blinking.
6. Fill a jug with about 100 milliliters of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator temperature (not hot!).
7. In order to get better milk foam performance, you are recommended to keep steam knob at open
position for approx 15s , since the early steam contains too much water.
8. Insert the steam wand into the milk about two centimeters, then turn the steam knob slowly in
anticlockwise to
position, steam will come out from the steam wand. Frothed milk is produced
by moving vessel round from up to down.
Note:
Never touch steam outlet during steam jetting and be careful not to burnt.
Note
: Never turn the steam knob rapidly, as the steam will accumulate rapidly in short time which may
increase the potential of the risk of explosion.
9. After frothing milk turn the steam knob to the
“O” position. Press
again.
10. Press
to turn off the device.
WARNING:
To avoid clogging of the steam nozzle after frothing follow these instructions: place an
empty cup under the frother and wait until the heating indicator turns blue. Twist slowly the steam knob
to
position and water will start coming out of the frother nozzle. After about 30 seconds, set the
knob at the
“O” position. Take off the plastic cover by pulling it downwards. Wipe the frother with a
damp sponge. Be careful not to burn yourself.