YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
28
Dimensions for the making of oil return bend are as follows:
A
B
(mm) | in.
C
(mm) | in.
mm
In.
Ф12
1/2
≥26 | ≥1.02”
≤150 | ≤5.9”
Ф16
5/8
≥33 | ≥ 1.3”
≤150 | ≤5.9”
Ф19
3/4
≥34 | ≥1.34”
≤150 | ≤5.9”
Pipe Flaring
1. Cut the connection pipe with a pipe cutter.
2. The mouth of connection pipe should face downward. Remove burrs with the cut surface so that the
chips do not enter the pipe.
3. Remove the cut-off valve of outdoor unit and take out the flare nut from the bag of indoor unit
accessories. Then fit the flare nut on the pipe and use a flaring tool to flare the mouth of connection
pipe.
4. Check whether the flaring part has cracked. (See the figure below).
Pipe Bending
1. The pipes are shaped by your hands. Be careful not to collapse, crush or kink them
2. Do not bend the pipes in an angle more than 90°.
3. If the pipe is repeatedly bent or extended, it will become hard and difficult to be bent or extended. So do not bend
or extend the pipe for more than 3 times.
