YMGI
•
Your Modern Green Idea
39
HIGH PRESSURE AND HIGH TEMPERATURE CLEANING IS NOT RECOMMENDED.
DOING SO COULD DAMAGE THE ALUMINUM FIN STOCK AND ELECTRICAL COMPONENT.
Clearance Check
Clearances around the unit should also be checked to make sure that the intake air and discharge air paths
have not become blocked or restricted. A minimum of eight inches clearance is needed from unit to furniture,
beds, or other objects for proper operation. Restricted discharge or intake air will reduce the unit's operational
performance. In severe airflow restrictions damage can occur to unit components such as the compressor,
electric heater or fan motor.
NORMAL OPERATING SOUNDS AND CONDITIONS
Water trickling sounds
Water is picked up and distributed over the coil. This improves the efficiency and helps with water removal.
Water dripping
Water will collect in the base pan during high humidity days. This can cause overflow and drip from the
outside of the unit.
Air sounds
The fan cycle switch sets the operational mode of the fan. In the ON position the fan will run continuously
whenever power is applied in this mode. In the AUTO position, the fan will cycle on and off with the
compressor or electric heater.
Starting delay
You may notice a few minutes delay in the starting if you try to restart the unit too soon after turning it off or if
you adjust the thermostat right after the compressor has shut off. This is due to a built
– in delay to protect the
compressor.
Buzzer Response
The buzzer will chime “Di” (0.1 sec) as response when receiving the effective order from key pad control and
remote control
