YMGI
•
Your Modern Green Idea
28
NOTE:
A baffle kit
must not
be used with a standard louvered grille on any PTAC installation.
Before installing the grille, remove the cardboard stiffener and rear enclosure panel from the wall sleeve.
These items can be removed from inside of the building. The sleeve stiffener must be taken out before the
rear sleeve enclosure panel can be removed from the sleeve.
Sleeve Stiffener Removal
Fold the two outside flaps “A” in and downward to remove.
Rear Enclosure Removal
Remove the rear enclosure by folding the front ends of the
top and bottom towards the center. Grasp the top and bottom
flanges as shown in Figure 2 and pull out diagonally from one
side of the sleeve.
Standard Louvered Grille Installation Instructions
1. Position the grille so that all four flanges are in the up
position.
2. Insert the six grommets provided so the square end
protrudes through the grille in the opposite direction
from the flanges.
3. Manipulate the grille out through the rear sleeve
opening using the plastic handle (not shown) provided.
4. Align the guide pins located in the lower right- and left
hand corners of the grille (Figure 3) with the
corresponding holes in the rear of the wall sleeve.
5. Secure the grille by threading each of the six screws
into the plastic grommets.
6. Remove the plastic handle (not shown) from the center
of the grille prior to installing the chassis into the
sleeve.
UNIT DAMAGE HAZARD
Be sure to keep a firm grip on the plastic handle and grille to prevent it from dropping and /or causing
possible injury or property damage.
