BRIEF UNIT INFO
BRIEF UNIT INFO
P14 OF 44
P13 OF 44
BEFORE INSTALLATION IDENTIFY COMPONENTS
Unit Appearance and Specifications Are Subject to Change for Continuous Improvement without Any Prior Notice.
INDOOR UNIT
Air Inlet
Air Intake Grilles
Temperature Sensor
Indicating Lamp &
Signal Receiving
Window
Emergency Switch
Horizontal Louver
Vertical Louver
Air Outlet
Air Filter
Remote Control
Air Inlet
Connecting Pipe
and Cable
Drainage Hose
Air Outlet
OUTDOOR UNIT
Mini Split Wall Mount Systems are designed for high performance, easy installation and service. Each system
consists of one or several indoor units and one outdoor unit, which are connected by one set or several multiple
sets of interconnection refrigerant pipes and electric wires.
As shown in the following sample picture of outdoor unit, air is drawn through the coil from the rear side and then
discharged from the front side. In cooling mode, air passing through coil is heated; in heating mode, air passing
through coil is cooled.
Sample Wall Mount Mini Split System (For Continuous Engineering Improvement and Various Marketing
Needs and Actual Part Availability Reason, Unit Appearance Subject to Change or Update Continuously
without Prior Notice)
Outdoor unit(s) provides the electrical and thermal power for the whole system. Electrical and thermal
components such as compressors and motors and heat exchange coils and others, are incorporated into the
cabinet in an optimized order. They can be either hung on the wall or installed on the ground. Once stacking or
bracket kit is used, some outdoor units can be stacked 2 or 3 units high, upon unit size and applications. Air is
discharged horizontally, quietly and smoothly. These units are perfect fit in locations where installation and
applications of general up-flow condensing units are limited, such as apartments, condos, lofts, multi-families and
high-rise buildings and others named or unnamed.
Indoor unit(s) delivers the thermal and acoustical comfort to the rooms. Air is drawn through the coil from the
front or topside and then discharged from the bottom. In cooling mode, air passing through coil is cooled; in
heating mode, air passing through coil is heated. Air is filtered or treated by the built in mechanism (washable or
enzyme equipped or electrostatic powered filter, varies from model to model), before being delivered into the
room, with more than enough comfort and care, at a wide angle (swing or not, varies from model to model).
Air In
Air Out
BRIEF INTRODUCTION TO MINI SPLIT WALL MOUNT SYSTEM
NOTES:
Since ductless system is not designed to incorporate or use with ducted return or discharge tunnels, one
single-zone unit SHALL NOT be used to take care of the cooling or heating load of more than one-story room.
Several single-zone ductless systems or multiple-zone ductless systems shall be proper in this regard.
These units are designed for applications at:
* Residential
* Light commercial
* Commercial
* Hospital
* Institutional
* Industrial
Apartments
Office Buildings
Homes
Application Samples of Wall Mount Mini Split Systems
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
