Y
ı
lmaz PVC ve Alm.
İş
leme Makineleri Ltd.
Ş
td
MK 420
40
7.2. CUTTING IN SHAPE PROCESS
7.2.1 For cutting in shape process the machine should be in a position as indicated in Figure 3. Fisrt of all loosen the
pipes placed on the set square and take out the set square group.
7.2.2 Remove the front protector (Figure 2 NO.120).
7.2.3 Install cutting in shape apparatus to its place as can be seen in Figure 3 and fasten with a M8 Imbus bolt.
7.2.4 Adjust the width dimension of the profile to be cut in shape through the dimension ruler (RESIM 3 NO.118) on
the shaft (Figure 3 NO.115) and fix the shaft by squeezing the squeezing handle (Figure 3 NO.51).
7.2.5 Adjust the saw raising height through the ruler placed on the front of the machine (Figure 2 NO.52).
After that by fastening both of the washers, (Figure 2 NO.50) fasten the saw.
7.2.6 Operate the machine and get to the back side of the machine.
7.2.7 Place the profile on to the table and lean one end of it to leaning profile (Figure 2 NO.116). Feed the profile
forward until cutting in shape process is completed.
7.2.8
Stop the machine after finishing working
7.3. CHANGING THE SAW
7.3.1 Disconnect from electric power supply.
7.3.2 Hold the saw from the bottom. Loosen the saw fastening washers (Figure 2 NO.50) by half opening the
squeezing handles (Figure 2 NO.51).
7.3.3 Remove the two M8 Imbus bolts (Figure 2 NO.93) with 6 Allen key placed on the table (Figure 2 NO.54)
7.3.4 Raise the table as can be seen in Figure 4 from the handle (Figure 2 NO.28). Meanwhile place the table raising
plate’s (Figure 4 NO.94) groove, to that of dolly’s (Figure 4 NO.29) and put the table in place. The table will
stand open itself (Figure 4).
(Be sure that the table is fixed appropriately; otherwise table may fall and cause
personel injury)
7.3.5 Take 17 key on one hand and a 15 key on the other. With key 17 hold M10 bolt (Figure 4 NO.75), and with the
other key, saw shaft (Figure 4 NO.69) through the key place.
7.3.6 Remove M10 bolt and then joint washer and external coupling in order (Figure 4 NO.73 and 74). Then remove
the saw and change with a new one. In reverse order install the items you removed.
IMPORTANT: Install the saw appropriate to direction of rotation. Label, indicating direction of rotation
is placed on the right hand side of the machine. Do not forget the tools, used for changing the saw, inside
or on the machine after completing the change process.
