YILMAZ REDÜKTÖR E Series, Operating Instructions Manual

Page: 29 / 52

Mounting
6.5- Check the mounting position;
The mounting position must be in accordance with the mounting position mentioned on the
name plate. If different please contact YILMAZ REDUKTOR for possibilities of using in a
different mounting position. Refer to the mounting positions and oil quantities on this manual
and adjust the oil level accordingly with the recommended oil types given on this manuel.
Do not mix synthetic oils with mineral oils which can cause serious damage on the gear unit.
6.6- Use of breather plug;
Breather plug is delivered with the gearbox together by YILMAZ REDUKTOR. Replace the
breather plug with the most top plug according to your mounting position.
As shown in the label below, the transport protection rubber must be removed before
operating the gear unit.
Some plug positions are not machined according mounting position. If no mounting position
is mentioned by ordering, the standard M1 position plugs are machined.
6.7- Check the oil level ;
On the mounting position tables the oil level plug is shown. Please refer to those tables and
be sure that the oil level is correct according the mounting position by screwing half way out
the level plug and see if oil comes out from that plug. If oil comes out tighten the plug again.
If no oil comes out take out the filling plug and add oil until oil comes out from the level plug
and tighten both plugs after finish. Be sure you are using the correct oil mentioned on the
oil tables on this manual.
Do not mix synthetic oils with mineral which can cause serious damage on the gear unit.
6.8- Check shaft ends and mounting faces;
Before you start to installing be sure that all the connection elements are free of oil and dust.
The output shaft may be protected by anti-corrosion oil. Please remove this using available
solvents on your market. By using this do not touch sealing lips or painting of the housing.
6.9- Cover abrasive ambient;
If the gear unit will be placed on a abrasive ambient be sure that the output seals are
covered so that no abrasive material, chemicals or water touches the seals. Any pressure
coming from outside over the seals can cause that the out staying substances to enter the
gearbox and cause serious damage to the gear unit. If pressure or abrasive material can
not be prevented from coming over the sealing, contact YILMAZ REDUKTOR for solutions.
Çalıştırmadan önce kullanım kılavuzunu mutlaka okuyunuz.
Please read operation instructions before operating.
TAŞIMA EMNİYET LASTİĞİ
Redüktörü devreye almadan önce
taşıma emniyet lastiğini çıkartınız.
TRANSPORT PROTECTION RUBBER
Remove the transport protection rubber
before operating the gear unit.
29
Operating Instructions
E Series