Safety
4- Safety
4.1- Intended Use
The gear reducer is designed for use in industrial machines. Please refer to our catalogue
or our web page for the maximum permitted torques and speeds. The most important maxi-
mum permitted values are indicated on the nameplate of the product. But the whole data
can be found on our product catalogues. Using the product out of the product catalogue /
nameplate’s permitted ranges will cancel the warranty/manufacturer declaration and YILMAZ
will not take any responsibility.
The gear units are intended for industrial machines and may only be used in accordance
with the information provided in this manual the product catalogue and the nameplate of
the gearbox. They comply with the applicable standards and regulations and meet the
requirements of the directive 2006/42/EC. The gearbox must be started up, maintained
and operated according this manual. The gearbox most be incorporated with 2006/42/EC
confirming parts/machines.
A motor connected to the gear unit is only allowed to be operated in the frequency entries
so that the data provided on nameplate/catalogue of the gear unit is not exceeded and is ac-
cordance with the nameplate/catalogue. The speed range will be provided on the name plate
if YILMAZ REDUKTOR is informed that the gear unit will be used with frequency inverter.
If not informed the nameplate will have a single fixed speed and only this speed is allowed.
The electric motor and frequency inverter must be in accordance with 2006/42/EC.
If the gear units input is used with variable speed gear unit, this must be informed to YILMAZ
REDUKTOR before ordering and on the nameplate the allowed maximum and minimum
speeds (speed range) will be provided. If not mentioned by ordering the gear units speed
will be a fixed single input speed and only this speed is allowed.
If the gear unit will be driven by belt / coupling / chain drive etc. the gear unit is only allowed
to be used according the nameplate/catalogue entries. Different speed, higher motor power,
higher radial/axial loads etc. than nameplate/catalogue is not allowed.
The ambient temperature must be b5 - +40
º
C and no abrasive media must attack
the paint and seals. If different working conditions this must be informed to YILMAZ before
ordering.
The gearbox maintenance (oil change / check ) must be done according this manual.
4.2- Improper Use
Every usage which exceeds the limits stated above, the nameplate and catalogue of the
product (especially higher torques and speeds) is not compliant with the regulations, and
thus prohibited.
The operation of the gear reducer is prohibited if;
-It was not mounted/installed according to regulations and this manual
-The gear reducer is very soiled
-It is operated without lubricant
-It is operated out of the permitted values provided on catalogues and/or nameplate.
21
Operating Instructions
E Series
Summary of Contents for E Series
Page 1: ...E Series Worm Gearboxes OPERATING INSTRUCTIONS OIECE0302 0422 ...
Page 47: ...Appendix ...
Page 50: ...Notlar ...
Page 51: ...Notlar ...
