User Manual
Yifan Industry Co., Ltd.
Page 15 of 41
Tel: +86 592 5222813 Fax:+86 592 6101492
Email: [email protected] , [email protected]
Website: www.yifanwireless.com
Chapter 3 Configuration
3.1 Configuration Connection
Before configuration, It
’
s necessary to connect the IP MODEM with the configure PC by the
shipped RS232 or RS232-485 conversion cable as following.
3.2 Configuration Introduction
There are two ways to configure the IP MODEM:
Configuration software tool: All the settings are configured through the shipped software tool.
It
’
s necessary to have one PC to run this tool.
Extended AT command: All the settings are configured through AT command, so any device
with serial port can configure it. Before configuration with extended AT command, you should
make IP MODEM enter configure state. The steps how to make IP MODEM enter configure
state, please refer to appendix.
The following describes how to configure IP MODEM with the configure software tool. At the
same time, it gives out the corresponding AT command of each configuration item.
3.3 Run the configure Tool: IP Modem Configure.exe
The
“
Serial Parameters
”
column shows the current serial port settings. To configure IP
MODEM, please choose the correct serial port which connects to IP MODEM, and the baud-rate
is 115200 with no parity, then open the serial port. If the button text is
“
Close
”
, it shows the serial
port now has been opened. If the text is
“
Open
”
, you should open the port first. When the port
opened, the
“
Output Info
”
column will display
“
Port(COM1) Has Opened
，
Please Re-Power the IP MODEM,
