Guangzhou Yingfeng Lighting Equipment Co.,Ltd
www.yf-light.com
4
5
、
Installation and change of the Lamp
1. In order to prolong the life of the moving head light as far as possible, please choose the
same type of lamp for it.
2. First of all to unscrew the four screws on the back cover of the moving head light, then
open the back cover, pinch the ceramic holder of the bulb and anti-clockwise rotation 90°
，
take out the lamp.
3. Open the bulb packing carefully, take out the new lamp, pinch lamp ceramic holder , insert
the lamp holder and 90°clockwise rotation
6
、
The connecting of the signal cable
Connected the XLR control cable from the DMX controller’s outlet to the first moving head
light’s input port , and connected from the first light’s DMX outlet to the second light’s DMX
input port, repeating the process, until all the lights are of connection. Then connected the
accompanied circuit plug to the last light’s signal output port, the connection finished, as
shown in figure:
Note: please remember to connect a circuit plug to the last moving head light’s signal
output port. Between the second and third pole of the CANON plug of this circuit plug have a
120Ω resistance, connect this circuit plug can avoid signal reflection phenomenon during the
DMX512 signal transmission process .
This Moving head use 3 pin XLR plug, If your controller use 5 pin XLR plug, you must use
a 5 pin to 3 pin patch cord. See below:
