Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
Visit:
www.yewdale.co.uk
3
Cassetted blinds with side channels:
N.B
.
This blind should be installed by a person competent in DIY. If in doubt
please consult a professional.
1
.
Remove the two safety screws in the underside of the headbox to enable the
cover to open (if the blind is a sidewinder, also unscrew the chain guide).
2
.
Using the indents (see figure below) within the headbox, drill 3.8mm fixing
holes either in the top or back depending on whether it is required to be face
or recess fixed. Fixing holes should be equally spaced and no more than 1m
apart to ensure head box is fixed completely level.
3
.
Lift the headbox into place and, if fitting to steel or concrete, mark with a
marker where holes need to be drilled so the hole can be plugged. Drill the
holes and lift the headbox into place and fix using the appropriate screws. If
timber, simply fix the headbox in place using the appropriate screws.
NB. To operate correctly, the blind MUST be fixed level.
4
.
Insert the barrel and fabric into the headbox. If the blind is spring
controlled, go to point 5. If it is sidewinder controlled, go to point 7. If it is
crank controlled, go to point 9. If it is electrically controlled, go to point 10
and refer to the motor instructions for setting limit stops.
5
.
Insert/click the blind on the back bar into the headbox. The spring must be
on the right-hand side unless the fabric is reverse rolled.
Top fixing position
Face fixing position
