Yetter Furrow Max 6200-070, Owner'S Manual, Page: 6 / 36

6
INSTALLATION INSTRUCTIONS
STEP 3:
Use the ½” x 3.75” pin, washers, and cotter pin to attach the spring to the disc pivot bracket. Use the
shoulder bolt and locknut to attach the cast closing disc arm to the main body. Use the 3/8” x 1.25” pin and
cotter pin to attach the spring to the cast arm in the 3
rd
hole.
Install the 6 x 12” rubber press wheel onto the rear mount using the 5/8 x 10.5” bolt and serrated flange nut,
putting a bushing on each side.
Use the 3/8 x .75” bolts to install the mud scraper. It can be adjusted up or down so it is close to the wheel,
but not touching.
Attach the closing disc’s to the cast arm using the 9/16 spacer between the disc and the arm only. (Additional
washers and spacers are for adjusting the disc’s wider or narrower)