Yetter 2967-180B, Operator'S / Instruction Manual W/ Parts Identification

Page: 6 / 16

ASSEMBLY INSTRUCTIONS
WARNING:
NEVER WORK UNDER THE EQUIPMENT WHILE IN A RAISED POSITION
WITHOUT USING SAFETY LOCK UPS. FAILURE TO DO SO MAY LEAD TO PERSONAL
INJURY OR DEATH.
STEP 1. Remove the coulter blade from the 2959 hub-assembly before attaching the residue
manager bracket. Remove the 5/8” bolt from the coulter arm assembly that secures the hub and
spindle assembly to the arm. Remove the hub and spindle assembly from the coulter arm. Insert
the 3/8” x 1 ½” bolt through the arm.
NOTE: The head of the bolt should be installed on the same side as the hub and blade will be
installed.
Replace the hub/spindle onto the arm and secure with the 5/8” bolt, lock washer and 2967-549 pin
adjustment plate. Also, install the 3
/8” lock hex nut onto the 3/8” x 1 ½” bolt. DO NOT fully tighten
at this time, fine tuning of alignment of adjustment holes will be done later.