To avoid contamination of food, please respekt the following instructions:
• Do not open the appliance lid more often than necessary. This may significantly increase the temperature inside the device.
• Foodstuffs should be stored in their original packaging or appropriate containers. Store raw meat and fish in suitable containers in the refrigerator, so that it is not
in contact with or drip onto other food.
• Clean regularly surfaces that can come in contact with food and accessible drainage systems.
• Too low or too high temperature may adversely affect the stored food. The temperature inside the refrigerator should be adjusted to the temperature
recommended by the food manufacturer. Optimum storage temperature for fresh food: 0°C - + 4°C.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mould developing within the appliance.
6. Operating
Warning!
Before turning the device on, connect it to a power source or install a charged battery (not included).
Powering the device using a solar panel (only with modular battery installed - not included)
Warning!
The device will be turned off if its not connected to another power source while the battery is removed.
Before inserting the battery into the device, make sure that its slot is free from dirt and unwanted objects.
Installing and removing the battery from the device
To insert the battery into the device, remove the battery slot cover by pressing its side buttons.
Then insert the modular battery into the slot while pressing the side buttons on the battery.
After releasing the buttons, make sure that the fastening locks securely hold the battery in the
slot.
To remove the battery from the device, release the locks by simultaneously pressing the side
buttons and then slide it out of the battery slot.
After removing the modular battery, it is recommended to reinstall the battery slot cover.
Warning!
It is prohibited to connect two types of external power source (DC / AC / solar panel) to the device. This may damage the
device.
When the device is powered by a solar panel, the battery should be in its slot in the device. To power the device with solar energy, connect the solar panel to the
DC socket. Solar panel power should be great er than the average energy consumption of the device. To enable simultaneous operation of the device and
charging of the battery, it is recommended to use a 100W solar panel.
Changing refrigerator lid direction
To change the lid direction, open it and tilt it 90 °, then slide it upwards. The lid should be turned and inserted into the openings in the housing on the opposite side
of the device. Before starting the device, make sure that the lid has been installed correctly and that it closes properly.
5. Directions for use
• Before first use, remove the device from the packaging, clean the inside of the device with a damp cloth and wait 6 hours.
• The device should be in a horizontal position during operation. The maximum angle of inclination of the device relative to the ground should not be more
than 5 °.
• If the device is used with the ignition off of a motor vehicle (when using a 12 / 24V power source), it switches itself off when the voltage drops below the
set battery protection value. The device will turn on again when the required voltage is obtained by charging the battery. The device must be turned off or
disconnected from the power source when charging the battery of the vehicle.
• The left chamber temperature should not be set lower than the right chamber temperature. This forces the compressor to work continuously, and thus
shortens its lifetime.
• When using an external battery, it is recommended to change the battery protection mode to low.
Solar
panel
socket
Battery protection mode
Switch-off voltage with 12V supply
Restart voltage with 12V power supply
Switch-off voltage with 24V supply
Restart voltage with 24V supply
Low (L)
8.5V
10.9V
21.3V
22.7V
Medium (M)
10.1V
11.4V
22.3V
23.7V
High (H)
11.1V
12.4V
24.3V
25.7V
