INSTALLATION
Read entire Installation Section before installing the CUT-65DS.
SAFETY
PRECAUTIONS
WARNING
ELECTRIC
SHOCK
CAN
KILL.
• Only qualified personnel should install this machine
• Turn the input power OFF at the disconnect switch or fuse box and discharge input capacitors before working
inside the equipment.
• Do not touch electrically hot parts
• Turn the CUT-65DS
Power Switch OFF when connecting power cord to input power
SELECT
PROPER
LOCATION
Place the CUT-65DS where clean cool air can freely circulate in and out the side louvers. Dirt, dust or any foreign material that can
be drawn into the machine should be kept at a minimum. Failure to observe these precautions
can result in excessive operating tem
peratures and nuisance shutdown of the machine.
A source Of clean, dry air must be supplied to the CUT•65DS
Oil in the air is a severe problem and must be avoided
The supply
pressure must be between 50.7 and 87 psi. Failure to observe these precautions
could result in excessive operating temperatures
Or damage to the torch
STACKING
The
CUT-65DS
cannot
be stacked
TILTING
The CUT-65DS must be placed on a stable, level surface so it will not topple over.
GAS INPUT CONNECTIONS (External
Air supply)
Supply the CUT-65DS with clean compressed
air
• Supply pressure must be between 0.3 and 0.6 Mpa.
(At a voltage of 1 IOV, Recommended
supply pressure
is between 0.3 and 0.45 Mpa;
pressure is between 0.4 and 0.6 Mpa)
-10
At a voltage of 220V, Recommended
supply