MyPBX Standard Administrator Guide
37
T.38 Support
Enable or disable T.38 FAX on this outbound route. Only for SIP
Trunk.
Rrmemory Hunt
Round Robin with memory. If it is enabled, MyPBX Standard will
remember which trunk was used last time, and then use the
next available trunk to call out.
Office Hours
This is an option to limit when the outbound route is available to
use. Usually we can select an office hours that is same as your
working hours, and the outbound route would be unavailable
after work.
2) Dial Patterns
A dial pattern is a unique set of digits that will select this route and send the call to
the designated trunks.Multiple Dial Patterns can be added on one outbound route
by clicking
button.
Table 7-2 Outbound Route-Dial Patterns
Patterns
X
Refers to any digit between 0 and 9
Z
Refers to any digit between 1 and 9
N
Refers to any digit between 2 and 9
[###]
Refers to any digit in the brackets, example [123] is 1 or 2 or 3.
Note that multiple numbers can be separated by dots and
ranges of numbers can be specified with a dash ([1.3.6-8])
would match the numbers 1,3,6,7 and 8.
. (dot)
Wildcard. Match any number of anything.
!
Used to initiate call processing as soon as it can be determined
that no other matches are possible.
Strip
Allow the users to specify the number of digits that will be stripped from the front of the
phone number before the call is placed.
For example, if users must press 0 before dialing a phone number, one digit should be
stripped from the dial string before the call is placed.
Prepend
Digits to prepend to a successful match. If the dialed number matches the patterns,
then this will be prepended before sending to the trunks.
For example if a trunk requires 10-digit dialing, but users are more comfortable with
7-digit dialing, this field could be used to prepend a 3-digit area code to all 7-digit phone
numbers before the calls are placed. When using analog trunks, a “w” character may
also be prepended to provide a slight delay before dialing.
3) Member Extensions
