MyPBX Enterprise User Manual
www.yeastar.com
Page 151
APPENDIX D How to Configure
NAT setting
When MyPBX is behind a NAT(firewall),you need to configure NAT
setting on MyPBX if you want to use a remote extension.
Please follow section
1
or
2
below depending on your network configuration.
1.
If MyPBX is connected to a local network, you must set up port forwarding
on your router. Specifically, you must map port 5060 (default SIP port) and
port 10001-10200 (default RTP port range) as UDP ports.
Next, go to the MyPBX web interface and configure the SIP settings
according to Figure C-1:
External IP Address
: your router‟s public IP address
External Host
: your router‟s domain
External Refresh Interval
: 20 seconds
Local Network Identification
:192.168.5.0/255.255.255.0 (change this
according to your network configuration)
NAT mode
: Yes
Allow RTP Reinvite
: No
Figure D-1
Assuming that your router‟s host address is yeastar.3322.org, your local
network is from 192.168.5.1-192.168.5.254, and the subnet Mask is
255.255.255.0, the MyPBX network settings should configured like Figure
D-2
Summary of Contents for MyPBX Enterprise
Page 1: ...Enterprise User Manual Version 10 17 0 32 Yeastar Technology Co Ltd...
Page 10: ...MyPBX Enterprise User Manual www yeastar com Page 10 Figure 3 2...
Page 157: ...MyPBX Enterprise User Manual www yeastar com Page 157 Figure F 2 Step3 Finish...
Page 163: ...MyPBX Enterprise User Manual www yeastar com Page 163 Figure H 3...