Configuring Call Preferences
105
5.
Select SIP Direct Call, and then press .
6.
Select the desired value from the pull-down list of Transport.
7.
Press the Save soft key to accept the change.
Yealink VC110 video conferencing endpoints support H.323 protocol. If your network
uses a gatekeeper, you can register an H.323 account for the endpoint, and specify its
H.323 name and extension. This allows others to call the endpoint by entering the H.323
name or extension instead of the IP address.
H.323 settings parameters on the endpoint are described below:
Parameter
Description
Configuration Method
H.323 Protocol
Enables or disables the H.323
protocol.
Default: Enabled.
Note: only when it is set to
enabled, can H.323 account be
registered. When it is set to
enabled on both sites, the
VC110 endpoint can call the far
site by dialing IP address
directly.
Remote Control
Web User Interface
H.323 Active
Enables or disables the H.323
account.
Default: Enabled
If it is set to disabled, the
endpoint cannot place or
receive calls with the H.323
protocol.
Remote Control
Web User Interface
H.323 Name
Specifies the name that
gatekeepers and gateways use
to identify this endpoint. You
can make point-to-point calls
using
H.323 names if both endpoints
are registered to a gatekeeper.
Default: Blank
Remote Control
Web User Interface
H.323 Extension
Specifies the extension that
gatekeepers and gateways use
Remote Control
Web User Interface
Summary of Contents for VC110
