Login to phone web administration interface
If there is no DHCP in your network, you can still auto provision your Yealink phone. Please
refer to your Yealink phone model User Guide for instruction about setting static IP address.
After you configure your Yealink phone to use a static IP address, continue with the following
steps.
Open a new browser window and enter your phone IP address in order to access the phone
■
web administration interface login screen. Example: http://192.168.1.22.
Login to the phone web administration interface with your username and password. Please
■
note, factory default login details are username: admin and password: admin.
Click on Upgrade tab.
■
Click on Advanced tab.
■
You can use TFTP or HTTP & HTTPS protocols in order to Auto Provision your Yealink
■
phone.
Choose which protocol you want to use:
■
TFTP
■
HTTP & HTTPS
■
TFTP
In the URL field enter Hostname or IP Address.
■
- Example for Hostname: https://voip.bicomsystems.com/
- Example for IP Address: tftp://192.168.1.10/
Make sure you replace Hostname or IP Address from this example with your PBXware
■
Hostname or IP address.
Check New Config
■
Select Power on + Repeatedly.
Click on the Confirm button.
■
You'll have to wait sometime prior for the device to save changes.
Click on the Auto Provision button to run auto provisioning process, then you'll be asked to
■
confirm action. To continue click on OK button.
Auto provisioning process will start during phone reboot process, phone will pickup
■
appropriate configuration file from PBXware. If everything is done as above described, you
should have successfully registered your phone to PBXware. Dial *123 to verify registration.
HTTP & HTTPS
This chapter describes how to use HTTP & HTTPS protocols in order to register Yealink phone.
NOTE:
Your PBXware needs to be configured correctly for this to work. Contact your
PBXware administrator. Bicom Systems can provide service to set up this for you.
