1. Tap the
OK
soft key on the CP930W, and then select
Register Handset
.
2. Select the desired base station and then tap the
OK
soft key.
The CP930W begins searching the base station.
3. Tap the
OK
soft key after searching a base station successfully.
4. Enter the base station PIN (default: 0000), and then tap the
Done
soft key to complete the
registration.
To register to multiple base stations, tap the
Menu
->
Settings
->
Registration
->
Register Hand-
set
, then repeat steps 2-4.
Note:
• If the CP930W is registered to the base station successfully, the LCD screen prompts
“Handset Subscribed” and “Base NO.”( the last 4 characters indicate the base station’s MAC
address).
• If the CP930W LCD screen prompts “Searching for Base”, check that your base station is
powered on.
Network Settings
You can configure the base station to obtain network settings in one of the following ways:
DHCP
By default, the base station attempts to contact a DHCP server in your network to obtain the val-
id network settings, such as IP address, subnet mask, gateway address and DNS address.
Static
If the base station cannot contact a DHCP server for any reason, you need to configure the IP
address, subnet mask, gateway address, primary DNS address and secondary DNS address for
the base station manually.
To configure the network parameters for the base station manually:
1. Tap the
Menu
->
Settings
->
Advanced Settings
(default PIN: 0000)->
Network
->
Basic
.
2. Select the desired IP addressing mode from the
IP Mode
field.
3. Select the desired IP addressing mode.
4. Make the desired changes.
5. Tap the
Save
soft key to accept the change.
Note:
• The DECT conference phone supports either or both IPv4 and IPv6 addressing modes, but
IPv6 is disabled by default.
• Wrong network settings may result in inaccessibility of your phone and may affect the
network performance. Contact your system administrator for the network parameters.
5
