50
English
B
C
A
AIR FILTER
A dirty or clogged air filter leads to a variety of problems including lower air intake, reduced engine power, increased
fuel consumption and a higher incidence of fouled spark plugs. After each use of your motorcycle, please follow the
instructions below.
(A) Clamp screw
Clean and maintain the air filter
1.
Loosen the clamp screw (A) and remove the cover to the air filter
2.
Remove the air filter.
3.
Use a mild detergent such as dish soap with water to wash both sides of the filter. Rinse thoroughly and allow
to air dry for 24 hours.
4.
Inspect the air filter and look for signs of dirt or build-up. If damaged, replace it with a new one.
5.
Once dry, apply a thin layer of fresh oil special for air filter
MOTUL
AIR FILTER OIL SPRAY and rub the areas gently
to
help remove any excess of oil (do not over-oil as it will cause
poor air intake)
6.
Put the (new) air filter back into the housing and re-attach with
the clamp screw.
*For the models
PILOT F125 and F150
,
FACTORY SP2 and SP3 also all BIGY
,
the air filter is integrated into the air box. To reach it, just remove the
3 screws of the box (B) then remove the screw "butterfly" located at
the right of the filter (C).
A
