YATO YT-82760, Original Instructions Manual

Page: 11 / 76

11
GB
O R I G I N A L I N S T R U C T I O N S
PRODUCT CHARACTERISTICS
Cordless screwdriver is a tool designed for screwing - unscrewing of various types of screws, bolts, nuts etc. by means of replace-
able screwdriver bits. Product has not been designed for economic activity. Correct, reliable and safe operation of the product
depends on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specified in this manual.
EQUIPMENT
Factory packaging should contain the screwdriver and charger.
TECHNICAL PARAMETERS
Parameter Measuring unit Value
Catalogue number YT-82760
Operating voltage [V] 3,6 DC
Rotation (idle running) [min -1 ] 230
Torque [Nm] 3.0
Noise level
- acoustic pressure [dB] 61,7 ± 3,0
- power L
WA
[dB] 72,7 ± 3,0
Protection class IPX0
Vibration level [m/s
2
] 0,39 ± 1,5
Insulation class III
Weight [kg] 0.35
Tool chuck [mm] 6
Battery type Li-ION
Battery capacity [mAh] 1300
Charger:
Input voltage: [V~] 230 - 240
Mains frequency [Hz] 50
Rated power [W] 5
Output voltage: [V] 5
Output current: [mA] 300
Charging time [h] 3 -5
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean.
Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket.
Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.