YATO YT-82240, Manual

Page: 13 / 72

13
GB
O R I G I N A L I N S T R U C T I O N
results in faster and more precise processing. The higher (fi ner) grit of abrasive belt, the lower but more precise processing. The
condition of belt should be checked in the course of work, worn or damaged belt should be replaced with new one before restart
of work.
Never use the previously used belt for the processing of other type of surface. For example the tape used previously for the
processing of metal surface should not be used for the processing of wood.
It is forbidden to use the grinder in other way than the tool operated using hands of the operator. Do not use the grinder as station-
ary tool affi xed to e.g. table by means of clamps. Grinder has not been designed for such a use and using it as the stationary tool
poses a serious threat of injuries to operator.
If the grinder is used for removal of varnish coating, it should be fi tted with dust extraction system and lowest pressure should be
applied during the work. Excessive pressure may lead to heat generation and consequently to dissolution of varnish coating. This
will lead to contamination and premature wear of abrasive belt as well as it may contaminate the material being processed.
Additional notes
Declared total value of vibration was measured by means of standardized test method and can be used to compare one tool with
the other. Declared total value of vibration can be used in the initial exposure assessment.
Warning! Emission of vibration when working with the tool may vary from the declared value, depending on how the tool is used.
Warning! It is required to determine safety measures to protect the operator, which are based on the exposure assessment in
real conditions of use (including all elements of work cycle, such as for example time when tool is switched off or idling and time
of activation).
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.