YATO YT-82207, Instruction Manual

Page: 14 / 76

14
GB
O R I G I N A L I N S T R U C T I O N S
When sanding, move the sander in a circular or reciprocating motion. Do not stop the sander in one place; this will cause uneven
work results. Do not apply excessive pressure on the sanded surface during sanding. The pressure should be uniform throughout
the entire working time. The sander should be guided in such a way that the sanding disc adheres to the sanded object with the
entire surface.
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and de fl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.