6
GB
O
R
I
G
I
N
A
L
I
N
S
T
R U
C
T
I
O
N
Remove the outlet nozzle securing nut. Clean the thread of the sand blast gun and the securing nut.
Install a new outlet nozzle and tighten properly the securing nut.
Work with the sand blast gun
Adjust the pressure in the pneumatic system not exceeding the maximum operating pressure for the sand blast gun so as not to
damage the surface to be cleaned.
Direct the nozzle mouth towards the surface to be cleaned and press the trigger.
During work with the sand blast gun large quantities of dust may be generated, so it is necessary to use personal protection
means, such as helmets with air supply, hearing protection and appropriate protective clothing.
Cleaning and maintenance
Once the work has concluded, disconnect the sand blast gun from the compressed air system and remove the coating material
remaining in the tank. Clean the enclosure with a soft cloth. Direct the nozzle towards a safe place and blow it for a couple of
seconds with clean air.
Clean thoroughly the whole route of the coating material. Careless cleaning will impair the parameters of the coating material
jet. Once the sand blast gun has been cleaned, the movable elements of the sealing must be coated with a small quantity of a
lubricant.
