YATO YG-05000, Original Instructions Manual

Page: 13 / 36

13
O R I G I N A L I N S T R U C T I O N S
GB
At the end of the day, you should remove food from the product to and transfer it to the refrigerator. If the product is equipped with
removable shelves, you should remove them and clean it manually outside of the product. The shelves should not be cleaned in
a dishwasher.
If on a tray at the bottom of the refrigerated display cabinet, cold water has collected it should be drained. If the product is equipped
with a water drain tube you should used it to drain, and then dry the residue.
Clean the product, by removing all the food leftover, that may remain in the product. Residues of the cleaning agent should be
removed with a soft cloth slightly soaked in clean water. Then dry all the surfaces with a dry soft cloth.
ATTENTION! The product is not intended for cleaning with a stream of water. Do not immerse the product in water.
The product is equipped with an automatic defrost system, that prevents the formation of frost in the cooling compartment. How-
ever, because of non ideal working conditions of the product, frequent opening of the door, placing in the cooling compartment not
quite chilled dishes, it is not able to completely prevent the accumulation of frost. Once a month you should carry out complete
defrosting of the product.
To do this, you should remove food from the product and transfer it to the refrigerator. Disconnect the plug of power cable from the
mains wall socket. Remove excess of water from the tray, Open the door and allow for spontaneous thaw of layer of frost. All the
time you should control the fill level of the water tray and empty the it so often, to prevent its overflow.
ATTENTION! It is prohibited to acceleration in any process of thawing of frost layer, for example. do not hammer the layer of frost,
do not pour water, do not apply stream of warm air on the layer of frost.
After you finish defrosting, you should wash the product in accordance with the recommendations described above.
Storage of the product
If the product will not be used for an extended period of time, you should completely remove food, and transfer it to the refrigerator.
Disconnect the plug of power cable from the mains wall socket. Thaw the layer of frost, remove excess of water from the tray, and
then thoroughly clean the product. Leave the door open in order to dry the Interior of the refrigirated display cabinet After drying
close the door.
Store the product indoors, protect against dust, dirt and moisture. It is recommended to store the product in the factory packag-
ing.
Store the product in its working position. Do not tilt, Do not put the products in layers. Do not place anything on the product.
Troubleshooting
The following are common faults, their causes and possible solutions. If you have any doubts, you should discontinue to use the
product, disconnect from the power supply and contact the manufacturer’s authorized service center.
Failure Possible cause Solution for the problem.
The product works loudly.
The product has not been leveled. Level the product
The product comes into contact with walls or other objects.
Set the product in accordance with the recommendations of this
manual.
The product is under-cooled.
Clogged or covered vents.
Unblock the vents. Set the product in accordance with the recom-
mendations of this manual.
Product is exposed to direct sunlight or is located near heat
sources.
Set the product in accordance with the recommendations of this
manual.
Foods placed without spaces in the cooling compartment.
Deploy products in the cooling compartment so it is possible air
circulation of between them.
the door is not close properly or he door seal is damaged.
Close the door or contact the manufacturer’s authorized service
center.
The product is working.
The product is not connected to a power source and is not
turned on.
Check correctness of the mains connection, switch on the product.
Damaged circuit of the power supply. Contact the manufacturer’s authorized service center.
Lack of power supply. Check the power source.
Product compressor works
without interruption.
The door of the product is open Close the door
There are too many food items is in the cooling compartment. Remove any excess food from the cooling compartment.
Disposal of the product
The product should not be placed together with other waste and must be disposed in a specialized establishment, in accordance
with local regulations. you should not remove the product nameplate because it contains information about the refrigerant and
foaming agent. However, if reading of this information will not be possible, you should pass this information to persons who will
carry out disposal of the product.