3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
3-11
165559-1CD
HW1481993
DX200 Standard Setup
5. Approx. seven minutes after the DX200 main power supply is turned
ON, the data will be written into FlashRom completely and the window
for touch panel calibration appears on the programming pendant. Use
a pen for touch panel or anything having a soft and sharp tip end (such
as ballpoint pen cap) to touch the center of the window for approx. two
seconds.
6. The cross cursor moves to the center, left top, left bottom, right bottom,
and then right top of the window in this order. Touch the center of the
cross for approx. two seconds for each.
NOTE
The cross cursor returns to the center if calibration fails. Try
calibration as described in step 6 again.
Use a pen for touch panel or
anything having a soft and
sharp tip end to touch the
center of the window for
approx. two seconds.
The cross cursor moves in such
an order as shown on the left.
20/44
