3-8
165559-1CD
HW1481993
DX200 Standard Setup
3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
3.2
Setting Up the Programming Pendant
The following two software need to be written into the programming
pendant.
For the normal setting up operation, the above two software need to be
installed. Also, upgrading of the application software (YPP.EXE, etc.) can
be solely executed to the already set-up programming pendant. In this
case, start from the step 9 of the following procedures.
1. Confirm that the main power supply of the DX200 is turned OFF.
2. Insert an USB or a CF to the programming pendant.
When inserting the CF, open the CF slot cover of the programming
pendant manually, insert the CF, and then close the CF slot cover. The
CF must be inserted with its front face upward.
<CF Slot Position>
<CF Inserting Direction>
(1) NK.BIN
: Operating-system software for the programming
pendant (managing software)
(2) YPP.EXE, etc.
: Application software for the programming pendant
CF slot
Insert the CF with this face upward.
17/44
