YASKAWA
TOEP C720600 05B LCD Keypad Attachment Installation Manual
13
◆
Install the Attachment (Procedure B)
De-energize the drive before you start the procedure.
DANGER
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized
drive. Before servicing, disconnect all power to the equipment and wait for the time specified on the warning label
at a minimum. The internal capacitor stays charged after the drive is de-energized. The charge indicator LED
extinguishes when the DC bus voltage decreases below 50 Vdc. When all indicators are OFF, measure for
dangerous voltages to make sure that the drive is safe. If you do work on the drive when it is energized, it will
cause serious injury or death from electrical shock.
1.
Remove the front cover from the drive.
NOTICE
Damage to Equipment. When you touch the option, make sure that you
observe correct electrostatic discharge (ESD) procedures. If you do not follow procedures, it can
cause ESD damage to the drive circuitry.
A - Front cover
Figure 5.7 Remove the Front Cover
2.
Remove the LED keypad.
A - LED Keypad
Figure 5.8 Remove the LED Keypad
3.
Connect the ground wire included with attachment to the drive ground terminal.
Connect the drive side of the ground wire to the drive ground terminal.
