YASKAWA JOHB-SMP3, Technical Manual

Page: 8 / 50

4 Option Components
8 YASKAWA SIEP C730600 0MA BACnet/IP Technical Manual
*2 LED labels are located on this label sheet. HV600 Bypass does not use an LED label.
Figure 3.1 LED Label Sheet
*3 The LED label has transparent background and white letters. Please make sure that you use the correct label for HV600 or FP605.
◆
Installation Tools
You can use these tools to install the option to the drive:
•
A Phillips screwdriver or slotted screwdriver (M3
*1
)
• Non-conductive tweezers or a tool with a tip width of approximately 0.5 mm (0.02 in) to set DIP switch S1.
• A pair of diagonal cutting pliers.
•
A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.
4 Option Components
◆
Option Components
A - Connector (CN5)
B - Installation hole
C - LED (NS)
*1
D - LED (MS)
*1
E - Ground terminal (FE) and installation hole
*2
F - Port 2 LED (10/100)
*1
G - Option modular connector CN1B (Port 2) (RJ45)
H - DIP switch S1
I - Port 2 LED (LINK/ACT)
*1
J - Port 1 LED (10/100)
*1
K - Option modular connector CN1A (Port 1) (RJ45)
L - Port 1 LED (LINK/ACT)
*1
Figure 4.1 Option PCB Components
*1 Refer to Table 4.2 for more information about the LEDs.
*2 Connect the included ground wire during installation.
◆
Communication Connector
Option connections CN1A (Port 1) and CN1B (Port 2) are connection points for customer-supplied BACnet/IP
network communication cables. These ports accept customer-supplied male 8-way ethernet modular RJ45
connectors.