YASKAWA iC9200 Series, Manual, Page: 47 / 124

2-pin connector:
Pos. Signal Description
1
,
2
DC 24V Plus DC 24V power supply, bridged in the plug.
3
,
4
0V Ground DC 24V power supply, bridged in the plug.
5
LED indication for power supply.
6
Locking lever
The CPU has an integrated power supply:
n
The power supply is to be provided with DC 24V, max. 1.5A. For this, the DC 24V
connection is used.
n
Both the CPU electronics and the electronics of the System SLIO periphery modules,
which are connected via the SliceBus , can be supplied with the supply voltage. An
additional power module is required for the power section supply of the System SLIO
periphery modules.
n
The power supply is protected against reverse polarity and overcurrent.
n You have the option to remove the connector of the power supply, e.g. for a module
change with fixed wiring. For this the connector has a locking lever. Ä Chap. 2.5.1
‘Wiring CPU’ page 20
n For easy wiring, each pole on the connector is 2-fold.
24pin USB-C jack:
Pin
A
Signal Description Pin
B
Signal Description
1 GND Ground 1 GND Ground
2 TX1+ High speed data path 1 + 2 TX2+ High speed data path 2 +
3 TX1- High speed data path 1 - 3 TX2- High speed data path 2 -
4 VBUS V 5V 4 VBUS V5V
5 CC1 Control channel 1 for
connector orientation
5 CC2 Control channel 2 for
connector orientation
6 D+ USB 2.0 data + 6 D+ USB 2.0 data +
7 D- USB 2.0 data - 7 D- USB 2.0 data -
8 n.c. reserved 8 n.c. reserved
9 VBUS V5V 9 VBUS V5V
10 RX2- High speed data path 2 - 10 RX1- High speed data path 1 -
11 RX2+ High speed data path 2 + 11 RX1+ High speed data path 1 +
12 GND Ground 12 GND Ground
n The interface is located under the front flap.
n The interface is not relevant for customer applications.
n The interface supports the USB 2.0 protocol and is used exclusively as a service
interface.
X6: Power supply
1
6
5
4
6
2
3
X7: USB-C
1
A
12
B
2 11
3 10
4 9
5 8
6 7
7 6
8 5
9 4
10 3
11 2
12 1
iC9200 Series
Hardware description
Structure > Interfaces
HB700 | CPU | PMC921xEx | en | 23-06 47