GPD315/V7 Modbus RTU Technical Manual TM 4325
Page
33
Notes:
1
Not Used registers and bits must be programmed with 0
2
Frequency reference depends on the setting of n152
3
Reserved registers cannot be accessed
4
Available in 10020 software or later
5
Range dependant on n018 setting
6
Value differs according to inverter capacity
7
Set to 0, Forward/Reverse command is set to terminal S3. S1 becomes the Run
command and S2 the Stop command.
8
Up/Down command is set to terminal S7 with S6 becoming the Up command and
terminal S7 the Down command.
9
Pulse frequency is 0 - 30kHz
10
Initialized to 0 by n001 set to 8 or 9 or initialized to 2 by n001 set to 10 or 11
11
Parameter cannot be set via Modbus (MEMOBUS)