YASKAWA FSDrive-MV1000 Series, Instructions For Use Manual

Page: 116 / 260

4.3 The Drive and Programming Modes
116 YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
n
Simplified Setup Using the Setup Group
The Setup Group lists the 32 parameters registered as User Parameters. This group expedites the startup process for an
application by showing only the most important parameters. Refer to
Figure 4.7 as an operation example.
Note: For details on the parameters of the setup mode, refer to Chapter 1 Parameter List of the FSDrive-MV1000 Parameter Guide
(TOEP C710687 03).
Figure 4.7 illustrates how to enter and how to change parameters in the Setup Group.
In this example, the Setup Group is accessed to change b1-01 from 1 to 0. This changes the source of the frequency
reference from the control circuit terminals to the digital operator.
Figure 4.7
Figure 4.7 Setup Group Example
<1> To edit a parameter set value, go to the right steps.
To confirm the parameter list displayed in the Setup Group, go to the steps below.
<2> To go back to the initial screen, press .
To edit another parameter in the Setup Group, press or .
← →
← →
Control Circuit
Terminal
Parameter Display
Digital Operator
<1>
<2>
HELP
- MODE - PRG
Quick Setting
DATA
FWD
Entry Accepted
- SETUP -
b1-01 = 1 ∗
1
∗
Analog Input
PRG
Ref Source 1
Rdy
Home
FWD
DATA
- SETUP -
A1-06 = 0 ∗
0
∗
General
PRG
Application Sel
Rdy
Home
FWD
DATA
- SETUP -
A1-02 = 2 ∗
2
∗
Open Loop Vector
PRG
Control Method
Rdy
Home
FWD
DATA
- SETUP -
b1-02 = 1 ∗
1
∗
Digital Inputs
PRG
Run Source 1
Rdy
Home
FWD
DATA
- SETUP -
L3-04 = 1 ∗
1
∗
General Purpose
PRG
StallP Decel Sel
Rdy
Home
FWD
DATA
“1”
- SETUP -
b1-01= 1 ∗
1
∗
Analog Input
PRG
Ref Source 1
Rdy
FWD
“1”
- SETUP -
b1-01= 0
∗
1
∗
Operator
PRG
Ref Source 1
Rdy
FWD