3
Deployment Touch Panel
3.1 Installation
The Touch Panel is suitable for the installation in operating tables and control cabinet
fronts. The installation happens via the back. The Touch Panel is provided with a
patented integrated fixing technique that allows an easy connection with a simple screw-
driver.
Due to the fact that the Touch Panel has a plug connector for bus connection and voltage
supply, a fast and easy device change is possible.
For the installation into a operating tableau and control cabinet fronts, the Touch Panel
requires the following front plate cutting:
Touch Panel
W x H in mm
62K-JID0-...
287 x 217
The fixing technique is integrated in the casing of the Touch Panel and accessible via the
back. For the installation, a small slit screwdriver is required
1.
Push the operator panel [3] from the front side into the front panel cutting [1] until it
touches the panel with the seal [2].
2.
Now bolt the lever [5] clockwise with the screwdriver [4] until it rotates to the out-
side.
3.
Further screwing bolts the lever to the front panel until it holds this to the control
cabinet front.
Overview
Installation cutting
Installation
VIPA HMI
Deployment Touch Panel
Installation
HB160 | TP | 62K-JID0 | en | 20-20
22
