Yardworks CCS48BCU, Instruction Manual, Page: 31 / 40

model no. 054-5775-8 | contact us: 1.866.523.5218
31
The following table gives checks and actions that you can perform if your machine does not
operate correctly. If these do not identify/remedy the problem, contact your service agent at
1-866-523-5281.
WARNING: Switch off and remove the battery pack before
investigating fault.
Troubleshooting
Symptom Possible Cause Remedy
Chainsaw fails to
operate.
Low battery charge.
Chain brake not in the proper
position.
Charge both the battery packs.
Check to see if the chain brake is in
position
1
. Refer to THE CHAIN
BRAKE section for details.
Chainsaw
operates
intermittently.
Over heating.
Applying too much pressure
while cutting
Loose connection.
Internal wiring defective.
On/Off switch defective.
Place the machine in a cool, ventilated
place to cool it down.
Applying relatively less pressure while
cutting.
Contact Yardworks ® at 1-866-523-5281.
Contact Yardworks
®
at 1-866-523-5281.
Contact Yardworks ® at 1-866-523-5281.
Dry chain.
No oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Refill oil.
Clean cap.
Clean oil passage outlet.
Brake does not stop chain Run-down kickback brake. Contact Yardworks
®
at 1-866-523-5281
Chain/chain bar
over-heats.
No oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Chain is over tensioned.
Dull chain.
Refill oil.
Clean cap.
Clean oil passage outlet.
Adjust chain tension.
Sharpen chain or replace.
Chainsaw rips,
vibrates, does not
saw properly.
Chain tension too loose.
Dull chain.
Chain worn out.
Chain teeth are facing in the
wrong direction.
Adjust chain tension.
Sharpen chain or replace.
Replace chain.
Reassemble with chain in correct
direction.