model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218
9
STARTING A WARM ENGINE
1. Move the start lever to the RUN position.
2. Squeeze and hold the throttle trigger.
Keep the throttle trigger fully squeezed
until the engine runs smoothly. Pull the
starter rope sharply while squeezing the
throttle trigger until the engine runs.
NOTE: Normally, the warm starting
procedure can be used within 5-10 minutes
after the unit is turned off. If the unit sits
for more than 10 minutes without being
run, it will be necessary to start the unit
by following the steps under STARTING
A COLD ENGINE or following the starting
instruction steps shown on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the start lever to the RUN position. Fully
squeeze the throttle trigger. Pull the starter
handle repeatedly while squeezing the
throttle trigger until the engine starts and
runs. This could require pulling the starter
handle many times, depending on how
If the unit still does not start, refer to the
TROUBLESHOOTING TABLE or call
1.866.523.5218.
OPERATING THE COUPLER
This model is equipped with a coupler
which enables optional attachments to be
installed. See your local retailer for available
attachments.
a
WARNING: Always stop the unit and
disconnect the spark plug before
SFNPWJOHPSJOTUBMMJOHBUUBDINFOUT
REMOVING TRIMMER ATTACHMENT (OR
OTHER OPTIONAL ATTACHMENTS)
CAUTION: When removing or installing
BUUBDINFOUTQMBDFUIFVOJUPOB«BU
TVSGBDFGPSTUBCJMJUZ
1. Loosen the coupler by turning the knob
counterclockwise.
2. Press and hold the locking/release
button.
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACHMENTS
1. Remove the shaft cap from the
attachment (if present).
2. Position the locking/release button of the
attachment into the guide recess of the
coupler.
3. Push the attachment into the coupler
until the locking/release button snaps
into the primary hole.
4. Before using the unit, tighten the knob
securely by turning it clockwise.
Operation
AD7428 Husqvarna Yardworks Trimmer Manual - EN.pdf 9
12/28/2015 10:35:47 AM
