ASSEMblY
WHEELS
This chipper was partially assembled at the factroy, following the below assembly instructions to do asembling.
1. Slide a wheel assembly on to each end of the stub axle as seen in
Figure 1 Illustration 1
. Place the flat washer onto exposed axel. (See
Figure 1 Illustration 2
) Take the cotter pin from Hardware Kit#1
and insert into and through the axle hole. Then, bend the ends of
the cotter pin. (See
Figure 1 Illustration 3
)
2. Align the three holes on the wheel axel bracket with the three
holes on the fan blower housing. (See
Figure 2, Illustration 1
) Then,
secure the wheel axel bracket with the three M8×12 bolts from
the Hardware Kit#2 as shown in
Figure 2, Illustration 2
.
Figure 1
Figure 2
× 2
1
M8 × 12
× 3
2
Wheel Shaft
1
2
3
Assembly Hole
1
2
M8 × 12
(×3)
16
mm
13
mm
18
mm
19
mm
30
mm
32
mm
9
|
Assembly
36060US25M100_KOHLER.indd 9
2017/10/17 11:06:04
