+
■
■
■
■
■
"
"
■
■
■
I
-----
--------
Gas Log Splitter
»
Operator's Manual
ASSEMBLY
This log splitter was partially assembled at the factory. To assemble your machine follow the below instructions.
WHEELS
1. At least two people are needed to move the reservoir outside
of the pallet. Place the engine at the end corner of the pallet.
Reservoir with Engine
ipping crate bottom
ing when installing
Figure2a
2. Remove the two anti-dust sleeves from the wheel axle.
Anti-dust51eeve(x2)
Figure2b
YU2566PM02-1703
65916US25M104_GB.indd 12
3. Assistant holds the engine, while the other person assembles
the wheel opposite of the engine first.
[)
Cotter Pin(x1)
Anti-dust Washenx11
Figure2c
M22
4XSO
X2
1
X2
X2
4. Slide the wheel with the valve stem facing out to the wheel
axle and the other roller bearing, then put the wheel washer
against the bearing. Use a 32mm socket to tighten the axle
nut completely.
5. Spin the wheel clockwise or counterclock wise to ensure
proper bearing seating.
6. Loosen the axle nut until it is loose enough to turn the wheel
with your fingers.
7. Retighten the axle nut until "finger tight."
Assembly I
12
2020/3/27 14:08:53
7
+
