AUGER
When engaged, the augers rotate and pull snow into
the auger housing.
DISCHARGE CHUTE
Snow drawn into the auger housing is discharged out
the discharge chute.
CHUTE CLEAN-OUT TOOL
The chute clean-out tool is conveniently fastened to
the rear of the auger housing with a mounting clip.
Should snow and ice become lodged in the discharge
chute during operation, proceed as follows to safely
clean the discharge chute and chute opening:
Release the auger clutch lever and shut off the engine.
Remove the clean-out tool from the clip which
secures it to the rear of the auger housing.
Grasp the tool firmly by the handle and push and twist the
tool into the discharge chute to dislodge the blockage.
Refasten the clean-out tool to the mounting clip on
the rear of the auger housing.
Make sure the discharge chute is pointed in a safe
direction (no vehicles, buildings, people, or other
objects are in the direction of discharge). Restart
the engine. While standing in the operator’s position
(behind the snow blower), engage the auger control
for a few seconds to clear any remaining snow and ice
from the auger housing and the discharge chute.
CHOKE CONTROL
The choke control is used to choke the carburetor
and assist in starting the engine. The choke control
switches between the CHOKE CLOSED
and
CHOKE OPEn
positions.
PRIMER
Press the primer to pump additional fuel from the
carburetor to the cylinder for improved cold weather
starting.
RECOIL STARTER HANDLE
The handle is used to start the engine.
SAFETY IGNITION SWITCH
Insert the safety ignition key for engine to start and
run. To stop the engine, remove the key.
RUN/STOP SWITCH
Used to stop the engine. Move switch to STOP
position to stop engine. Place switch in RUn position
for engine to start and run.
ELECTRIC STARTER & START BUTTON
The electric starter will start a properly choked and
primed engine when start button (120V AC) is pushed.
To start the machine, connect the electric starter to
an electric power source with an approved extension
cord and press the start button.
FUEL SHUTOFF VALVE
Always operate the snow blower with the fuel shut-off
valve in the OPEn position. Close the valve when you do
not use the machine.
Do not substitute. Use only original equipment shear
pins as supplied with your snow blower.
Never use your hands to clear a clogged discharge
chute . Shut off engine and remain behind handles
until all moving parts have stopped before unclogging.
1.
2.
3.
4.
5.
Never use choke to stop engine.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged, do
not operate the machine. Replace or repair the
damaged cord immediately.
Connect extension cord to the electric starter
plug-in first and then to a power outlet; disconnect
the extension cord from the power outlet first and
then from the machine.
To prevent damaging the electric starter, do not run
it more than 5 continuous seconds each time you try
to start. Wait 10 seconds between each attempt.
15
YB6270PM01 - 1708
|
Know Your Machine
30255JUS25M101_GB.indd 15
2017/8/24 19:25:11
