OPERATING INSTRUCTIONS
Using the Blower
Blower
Vacuum
blow
USING THE TOOL AS A BLOWER
Converting to a Blower
Flip-Lever
18
1. Place the shoulder harness over the head and on the shoulder, and adjust it if necessary. Refer to the section entitled
Installing the Shoulder Harness.
2. Start the Blower/Vac. See the section entitled Starting/Stopping Instructions.
3. Set the Blower/Vac mode flip-lever to the up position (Blower Mode) (Fig. 20).
NOTE:
Do not use the Blower/Vac if the lever is halfway between the modes.
Hold the blower as shown in Figures 21, 22, and 23. Sweep from side to side, with the nozzle several inches above the
ground or floor. Slowly advance the blower, keeping the accumulated pile of debris in front.
Most dry blowing operations are better suited to low speeds rather than high speeds. High-speed blowing is better suited
to moving heavier items such as large debris or gravel.
1. Use the blower for trees, shrubs, flower beds, and hard-to-clean areas (Fig. 21).
2. Use the blower around buildings and for other normal cleaning procedures (Fig. 22).
3. Use the blower around walls, overhangs, fences, and screens (Fig. 23).
Fig. 20
Fig. 21
Fig. 22
Fig. 23
