![background image](http://html1.mh-extra.com/html/yard-force/y4gt-a40-d001/y4gt-a40-d001_operators-manual_905873019.webp)
17
of the line location notches in the spool head and the other into the opposing
notch.
•
With the spring fitted onto the shaft of the spool holder insert the spool back
into the holder. As you insert the spool, thread the lines through the eyelets
and pull firmly to disengage the line from the notches in the spool. (Fig. M)
15cm
15cm
NOTE
When inserting the spool into the housing, the spool may need to be rotated
slightly so as to locate into the housing. Before the spool is fully inserted into the
housing, ensure the lines are free from the notches on the spool.
•
Once the spool is fully inserted and the lines are fully through the eyelets, pull
firmly on each line to disengage the lines from the spool notches. Ensure the
lines are fully clear of the spool notches and the line is passing through the
eyelets directly to the spool.
•
Whilst maintaining pressure against the spring refit the bottom plate to the
spool holder.
•
Check that the lock tabs are engaged
•
Check that the bump knob is free to move up and down. If it does not move
then most likely the cutting line is jamming it and will need to be cleared before
using.
•
Cut both cutting lines so that they protrude from the spool assembly evenly.
NOTE
On start up test the operation of the bump feed to ensure the line feeds correctly.
MAINTENANCE AND STORAGE
Fig. M