50
51
Trimming
This option determines if the mower will carry out boundary trimming during
a mowing cycle. Select the option “Yes” to carry out boundary trimming. To
determine the width of the boundary edge, see the section: Width.
Note
：
The boundary cable must be carefully checked before confirming
this option. The mower may cut the boundary cable when the cable is
not properly fixed to the ground.
Width
This option determines the distance (0.1-0.4 m) the mower will run past the
boundary cable when performing boundary trimming.
Signal
This option determines which signal (S1 or S2) is using for the boundary cable.
If both you and your neighbour have the same Yard Force Robomower and the
boundary
cables between the two mowers is less than 10 m apart from each other, set the
signal (S1 or S2) of your boundary cable to a different one from your neighbour.
For example, if your neighbour’s mower is already connected through signal S1,
connect your mower to the charging station through signal S2. On the charging
station, you must also carry out the corresponding change. To set the signal to
S2 on the charging station:
Press the button again to change the signal of the charging station back to S1.
•
PIN
This option sets the passcode of the mower to prevent theft or unauthorised
change of the menu settings. The existing (old) passcode is required to change to
a new passcode. If you have forgotten the passcode, contact your local dealer or
after sales service.
The default passcode of the mower is “0000”.
•
Rain
Mowing in the rain is not recommended.
This machine has a rain sensor which may stop the robot from mowing in the rain.
When the rain sensor is triggered, the robot will go back to the charging station
first, where it will be fully charged. Once charged the mower will remain in the
charging station until the rain has stopped before starting to mow again.
Note: Be careful not to short circuit the sensors on the machine with any
metal objects. This will cause the mower to work abnormally.
Rain sensor
Users can activate or deactivate the rain sensor as shown below:
Deactivating rain sensor:
OPERATION
OPERATION
