19
ASSEMBLY
Attaching the hose to the spray wand handle (Fig. C and D)
The hose is preassembled to the spray wand handle and sprayer. If the hose becomes loose,
it should be re-connected securely again.
a). Push one end of the hose into the spray wand handle.
b). Connect the nut by rotating clockwise.
c). Connect the opposite end of the hose to the sprayer.
Attaching the shoulder strap
a). Clip the ends of the shoulder strap to the mounting points on both ends of the sprayer.
b). To use the shoulder strap, simply slide the strap over your shoulder.
Charging the battery (Fig. E)
WARNING! Remove the battery from the charger after it is fully charged.
WARNING! The battery has been shipped in a low charge condition, it should
be fully charged before first use.
a)
Connect the charger to the mains. The green power indicator light on the charger will be
on when connected.
b)
Insert the battery into the charger until it is locked in place. The charging indicator light
on the charger will be red.
c)
It takes about 90 minutes to fully charge the battery. The charging indicator light on the
charger will be green.
d)
The battery has three LED power level indicators to show the state of the battery charge.
Press the button on the right of the LED power level indicators to see the power level.
•
One LED light on - low state of charge, requires charging soon.
•
Two LED lights on - middle state of charge
•
Three LED lights on - fully charged
Inserting and removing the battery
WARNING:
Before inserting or removing the battery from the sprayer, make sure
the sprayer is switched off.
a)
To insert the battery, align the battery with the sprayer's battery compartment and slide
OPERATION