6
Please contact 1-888-723-6534 for further assistance.
Assembly
1
Attach the Axle Support
and remove the two M6 wing nuts (X) on the wheel axle
supports. Fold the wheel axle supports in towards each
other. Then reinstall the M6 wing nuts (X) to the bottom
assembly (A).
2
Attach Tongue Support
CAUTION:
Pay attention to the orientation of the hole during
assembly. The hole on tongue support (K) should be on the right
side.
Attach the tongue support (K) to the back of the bottom panel (A).
Pay attention to the orientation of the hole on the tongue support.
The hole should be oriented as shown below. Install four sets of
M6x16 screws (AA), Ø6 lock washers (BB) and M6 hex nuts (CC).
Hardware can be tightened later when cart is turned upright.
Hardware Used
x 2
M6 Wing Nut
X
X
K
AA
BB
CC
Hardware Used
AA
x 4
M6x16 Screw
x 4
Ø6 Lock Washer
BB
x 4
M6 Hex Nut
CC
X
X
A
A
Lay down the bottom panel assembly (A) on a flat surface,
