115
5. Place the accelerator pedal to idle position.
6. Direct the machine towards the ramp plates at low speed and load the machine onto the truck.
Do not use levers other than the side movement levers when travelling across the ramp plates.
15.2 Immobilising the machine on the truck
Once the machine is in a suitable position on the truck, immobilise it as follows :
1. Lower the blade to the ground.
2. Fold the bucket and the arm to the maximum, then
lower the boom to wedge the arm on a wooden block. (a)
3. Turn the key to OFF position to switch off the engine
and disconnect the electrical circuit. Remove the key
from the ignition.
4. Lock the control levers with the locking lever.
1 = Locking
2 = Locking lever
3= Left hand side
Note
The hydraulic brake locks the rotation motor.
15.3 Tying down the machine
WARNING
Do not perform the tie-down if a person stands on the machine or on an accessory.
WARNING
Use a tie-down accessory (belt, chain, cable) compatible with the
weight of the machine and compliant with European standards.
Check the tie-down accessory labelling to know the WLL
3
. In the ab-
sence of or damage to the accessory labelling, do not use it without
being assured of its WLL
3
.
3.
Working Load Limit
(WLL)
1= Wedge
2=Anchor points
Summary of Contents for SV26
