PRODUCT OVERVIEW
JH Series Operation Manual
33
Single-Lever Remote Control
Handle
Figure 9
Figure 22
Note: Direction of travel will vary
depending on installation location.
1 – Low Speed - FWD or REV
2 – Low Speed - FWD or REV
3 – NEUTRAL - Power to the
propeller shaft is cut off and
the engine idles
4 – Maximum Engine Speed - FWD
or REV
5 – Maximum Engine Speed - FWD
or REV
should
be used to operate the marine gear clutch
(NEUTRAL, FORWARD and REVERSE)
and to control the engine speed.
The handle controls the direction of the
boat (ahead or astern) and also acts as an
accelerator by increasing engine speed as
the lever is pushed further in FORWARD
or REVERSE directions.
When the handle is pulled out
(Figure 23, (1))
, the engine speed can be
controlled without engaging the clutch.
The clutch remains in NEUTRAL, no load
position. Turn the knob
(Figure 23, (2))
counterclockwise to move the handle or
clockwise to lock the handle.
Figure 23
Note: YANMAR recommends the use of a
single-lever type for the remote
control system. If only a two-lever
type is available in the market,
reduce engine speed to 1000 min
-1
or less before engaging and
disengaging the marine gear clutch.
1
4
3
2
5
K0004504
2
1
K0004511
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book 33 ページ ２０２２年９月２２日 木曜日 午後６時１７分
