YANGZI YZ-S6, Instruction Manual

Page: 6 / 10

5
1. Adjustment of sidebrush
Under normal working conditions, the brush should
be at the left position above the ground. If the brush
is too low from the ground, it is easy to cause load
heating overload and accelerate the wear of
brush hair. Motor burned out, brush height
adjustment method: adjust the panel side brush button
2. Replacement of sidebrush
Screw out the screw 1,
remove the side brush, screw
out the screw 2, and replace
the side brush
The height of the main
brush contacting the ground should be 2-4mm. When the main brush contacts the
ground too low, the normal operation of the machine will be affected, and the parts are
easy to heat up, thus reducing the service life of the machine.
3. Adjustment of mainbrush
The height of the main brush contacting the ground can be determined by adjusting
the limit screw.
replacement of main brush
Screw out the screws 1 to
4, remove the rocker arm
and left baffle, and pull
out the mainbrush.
When replacing, pay
attention to the installation
direction of the main brush, and do not reverse the direction.